The Canadian made castings were thicker at the bolting flange
then the TA series. The addition of tie rods through the castings provided ruggedness to
the loader and solved the problem of the castings coming loose in the
field. A
"Y" strainer and pilot pressure filter were added to the air supply
line to offer additional protection. The Air Pressure Regulator used on the
early production loader was the same as the units used on the TA5 series. These
where retained to the mounting bracket by four bolts. This regulator model was
discontinued by the manufacturer, and the replacement unit was retained by a
large plastic nut. To
reduce stress to the piping system and components an additional support bracket was added.
ruggedness to
the loader and solved the problem of the castings coming loose in the
field. A
"Y" strainer and pilot pressure filter were added to the air supply
line to offer additional protection. The Air Pressure Regulator used on the
early production loader was the same as the units used on the TA5 series. These
where retained to the mounting bracket by four bolts. This regulator model was
discontinued by the manufacturer, and the replacement unit was retained by a
large plastic nut. To
reduce stress to the piping system and components an additional support bracket was added.